Line Vac Paired With a Chip Vac Container

The EXAIR Line Vac is used for a variety of applications across multiple industries and has proved to be very versatile.  One common application we have for these units is to remove chips, trimmings, or debris from an area of operation, like is shown below where chips from drive train differentials are removed using this setup with a 2” Line Vac. The Line Vac is positioned at the top of this custom assembly and the bottom shroud fits over the drive train casting. It has internal nozzles to positive air flow to direct the chips into the vacuum flow of the Line Vac.

For some of these applications the discharge port of the hose is just aimed into a bin or some form of a drum without a lid or filter anything to keep dust at bay. In other operations it may be going straight into something as small as a 5 gallon bucket.   Rather than blowing all of this debris, or sand, or dirt into air an open top container and risk it getting stirred up and released into the air, or missing the container and falling onto the floor you could channel it all into one container with one of our Chip Vac Containers.


            The Chip Vac systems are offered in 55 Gallon Drum, 30 Gallon Drums, and a 5 Gallon Container sizes.  Each of these is fitted with an EXAIR .1 micron filter bag that is both washable, and replaceable.  The advantage to using one of these Chip Vac Drum Lid Assemblies is that your debris can be contained into the correctly sized container for your operation and all of the exhaust air will be filtered by the .1 micron bag which means your trimmings, or chips, or sand will all remain in the container rather than blowing out onto the floor or going back into the atmosphere of your shop.

            The 30 Gallon Lid and the 55 Gallon Lid and 5 Gallon Lid all have a 2″ NPT Bung opening that you can adapt to fit your Line Vac hose size.  Pair the lid with a matching size drum dolly and when your drum is full simply remove the lid, wheel the full drum out of the way and a new empty drum in its place.

            We have seen this work in multiple applications as collecting sand from a drilling operation that was being performed on a sand casting, to material trim removal and metal chip removal from machining operations.   If you want more information on these or have a similar application feel free to contact me.

Brian Farno

Application Engineer