A little while back, I was contacted by a customer who was looking for a way to clean chips and debris out of tapped holes in an engine block. They were familiar with our products, having used them in several different areas in their plant, and had done some early research into our Air Nozzles.
They were considering using our small M4 Back Blow Air Nozzle in the process. The Back Blow Air Nozzles produce a 360° airflow that blows away from the end of the nozzle and in many cases, are the ideal solution for treating the inside diameter of hose, pipe, machined holes, etc. These unique nozzles, eliminate the concern of forcing particulate further down into a machined hole or the safety issue of blowing material out of the opposite end of an open tube or pipe.
In this particular case, having the material blown out of the hole increased the risk of possible cross contamination somewhere else in the engine block so they were also thinking of incorporating some type of recovery system like our Chip Vac or one of our Line Vacs but were concerned with having to use two separate devices.
Once again, EXAIR has the perfect solution, the Deep Hole Vac-u-Gun. The Deep Hole Vac-u-Gun features a small blow tube (1/8″ OD) that provides a small blast of air to dislodge or loosen foreign material while simultaneously providing vacuum to carry the debris away.