Mini Cooler Provides Cooling Solution In Induction Heating Process

I was recently contacted by an automation company using an induction heating process to heat the flared end of 2 nickel alloy parts, less than 1″ long with a 7/8″ flared end. The parts are only a few inches apart and they are heating the flared end to around 170°C and holding the temperature for about 1 second. They then cool the flared ends by using compressed air blowing through a homemade manifold with drilled holes directing the air across the parts to cool them to room temperature. The homemade manifolds were being used because they were behind schedule on the original project and needed a “quick fix”. While the current setup was working, they were using approximately 30 SCFM of compressed air with a cooling time of around 10 seconds and the operation was very loud. Looking to make some improvements to reduce the amount of air they were using, decrease the cooling cycle and lower the sound level, they turned to EXAIR for assistance.

I recommended they use our Model # 3308 Mini Cooler System with two cold outlets. The Mini Cooler incorporates a Vortex Tube and provides a 50°F temperature drop from compressed air supply temperature – in this case the outlet temperature from the Mini Cooler will be about 30°F. The dual point hose kit splits the cold airflow into two separate airstreams, allowing for a wider treatment area, or in this particular application, the ability to cool two separate parts with just one device. The unit consumes only 8 SCFM @ 100 PSIG, much less than the current 30 SCFM the customer is using now, and produces a low sound level of only 76 dBA. It also incorporates a swivel magnetic base, so installation is simple, making it easy to replace the existing setup.

Mini Cooler
Model 3308 Mini Cooler System – includes Mini Cooler, Dual Point Hose Kit, Swivel Mag Base and Filter Separator.

If you have a cooling application you would like to discuss, please contact one of our application engineers at 800-903-9247 for assistance.

Justin Nicholl
Application Engineer
justinnicholl@exair.com
@EXAIR_JN

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s