As the weather in the Northern Hemisphere changes over from winter to spring and temperatures start to climb, it is slowly becoming necessary for customers to utilize the Cabinet Cooler Systems to keep control panels cool.
One such situation involved a customer who was building a panel for his client in Malaysia. Malaysia is about 3 degrees north of the Equator, so it is what I would call a semi-tropical if not tropical environment. And such places are quite high in humidity levels. This customer had a client who was in the palm oil processing industry which is quite big in Malaysia. He needed a Cabinet Cooler System to generate about 1000 Btu/hr. of cooling power in a NEMA 12 type system. So I recommended he go with a 1700 Btu/hr. Cabinet Cooler System so he had plenty of capacity. I also recommended he go with 24 VDC thermostat control so he could easily pull the power out from within his panel and not have to run any new circuits.
As the customer duly noted, the fact that the Cabinet Cooler System purges the cabinet with clean, cool and dry compressed air allows for the humidity levels to hang down at a much lower level around 40 – 50% RH instead of up around 80 – 90%. This is attributed to the processing and drying of the compressed air at the production point before it is sent out to the facility and again at the point of use with the included, 5 micron, compressed air filter/separator that comes with each system.
Previously, the customer was using only the small, DC type fans to pull that hot, humid air through the panel which led to many corrosion issues and did not relieve the heat issue at all. With this new improvement, the end user no longer has to worry about such issues. Also, there is virtually no maintenance for this system which produces much longer up-times for the customer as there are no moving parts to wear out. Overall, it was a good recommendation in this case as the Cabinet Cooler System was handling multiple, previously negative issues. Now the pain has been taken away and the end user can move on to solving other, more pressing problems.
Neal Raker, Application Engineer