Siphon Fed Atomizing Nozzle Improves Roll Forming Process

Last week I worked with a gutter manufacturer who was looking for a way to spray a light coating of vanishing oil on the rollers of a forming machine. Roll forming is commonly used when needing to maintain a constant and consistent shape or feature across the length of the part. In this particular case, a sheet of aluminum, used as a cover for the gutter, is fed into the machine where it passes over a series of dyes that bends “ribs” and punches small holes into the part to keep leaves or debris from settling on top, while allowing the rainwater to pass through the holes and into the gutter.

They were needing to apply the oil to the rollers because they were starting to see some irregularities in hole size as well as some deformities to the shape of the ribs due to heat being generated during the forming process. The customer was interested in using some type of atomizing spray nozzle in the hopes that providing an atomized mist of liquid may provide for a faster evaporation of the oil so there wasn’t much residue left on the part before packaging.

After further discussing the details, they advised that they were going to have the oil in a container about 12″ below the machine but didn’t have a way to pressurize or pump the liquid to the nozzle. Once again, EXAIR has the perfect solution with our 1/4 NPT Siphon Fed Atomizing Nozzles. These nozzles are the ideal solution where pressurized liquid isn’t available as they use the compressed air to the draw the liquid into the nozzle, up to 36″ of suction height, and mix it internally to produce a mist of atomized liquid spray. For this particular application, the Model # SR1010SS was a good solution as it provides a low flow rate of only 0.8 GPH and a tight spray pattern to focus right at the rollers to avoid any waste or overspray.

sr1010ss

Model # SR1010SS Siphon Fed Round Pattern Atomizing Spray Nozzle – 303ss construction, fully adjustable flow rate

EXAIR offers an extensive range of Atomizing Nozzles that can be used for light coating applications, like above, or for wider coverage areas or higher flow rates. For help selecting the best option to fit your needs, contact one of our application engineers for assistance.

Justin Nicholl
Application Engineer
justinnicholl@exair.com
@EXAIR_JN

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: