Floating Plates With Compressed Air

Yesterday, I had the opportunity to work with a customer who was familiar with our product and was looking to roll out EXAIR’s Super Air Nozzle in various parts of the plant. Before purchasing our products, the customer was using (4) open 5/16″ aluminum tubing to move or “float” a 12 inches by 12 inches plate of aluminum. This plate is .187 inches thick and needed to be moved six inches against the wall of their conveyor. The (4) open tubes moved the plate, but the customer had some safety concerns. First, the open pipes violated the OSHA standard 1910.242(b) that any open pipe that can be dead ended must only be pressurized to 30 PSIG. Second, to move the plate successfully the shop pressure needed increase to 100 PSIG which increases the amount of load on the compressor and could lead to higher maintenance in the future. Finally, the noise level of open pipes was well over 110 dBA which was another OSHA violation.

1132ss

Considering all of these problems the customer contacted me, looking for an air nozzle to use instead of the open pipe. After a short discussion we decided to try (3) HP 1125 nozzles. Once the customer installed the air nozzles, they only used 2 of the air nozzles, and they were able to move the plate easily across the conveyor. This netted them several key results. The most noticeable at the plant was how quiet the operation became. Instead of dealing with noise levels in excess of 110 dBa (which is equivalent to the noise level of a turbo-fan aircraft at take off)  the HP1125 comes in at 83 dBA which is roughly the noise of a milling machine.  This was much more pleasant to the operator and any plant passersby.  The most important was the operation now complied with OSHA safety requirement of 1910.242(b).  Because of the width of the Flat Nozzle and the overhang of the cap, the nozzle can not be dead ended.  Since the unit can not be dead ended, pressure above 30 PSIG can be safely used.  Finally, the most economically result was that the air savings for the units.

The 5/16 tube had an ID of .183 and was 18″ long. When supplying it with 100 PSIG of compressed air, it will flow 22.8 SCFM of compressed air, so the customer was using 91.3 SCFM. The HP1125 nozzle uses 37 SCFM at 80 PSIG, so they were able to use 74 SCFM, which means each minute they were using 17.3 fewer cubic feet. At a cost of $0.25 per 1,000 Cubic feet, the HP1125 saved $0.26 per hour or $6.23 per day or $1,557 per year with 250 working days.

Replacing (4) open tubes with (2) HP1125 Flat Super saved $1,557 per year in compressed air savings, an OSHA violation, employees hearing, and lowered the system pressure from 100 psi to 80 psi.  Needless to say the customer was sold on the benefits on our products, and is looking for any more open pipes in his facility.

Dave Woerner
Application Engineer
Davewoerner@EXAIR.com
@EXAIR_DW

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: