The key towards a successful Super Air Knife application is making sure it’s installed properly. Using the chart on the installation & maintenance guide to ensure your plumbing is properly sized is the first step. This ensures that an adequate volume of compressed air is able to reach the knife, without causing an unnecessary pressure drop.
Once you’ve planned out the distribution of compressed air to the Super Air Knife you must consider how to mount it in your application. Across the bottom of the knife are ¼-20 tapped holes spaced out evenly every 2” along the knife. A 30” Model 110030 will have (15) holes, a 60” 110060 (30), and so on. These holes are tapped through to allow you to mount the knife to best suit the application.
If you’d rather have a more “out of the box” solution, EXAIR offers our Universal Mounting System. It gives you the ability to mount onto a conveyor rail or machine frame and provide precise positioning for all of EXAIR’s Super Air Knives, Standard Air Knives, Full-Flow Air Knives, as well as the Standard and Super Ion Air Knives. Each system comes with (2) 1/2-13 x 5” long bolts, 2’ long stainless steel rod, mounting hardware, angle bracket, and adjustable swivel clamps. Check out the video below for a demonstration of the adjustability you can achieve with the Model 9060 Universal Mounting System.
Another critical factor to consider is the mounting position of the knife. If the material is moving along a conveyor, the knife should be positioned as closely as possible with the airflow oriented against the direction of travel of the material. By doing so, we increase the amount of time that the material is in contact with the airflow. We call this term counter-flow. Maximizing the time in contact with the laminar airflow from the Super Air Knife gives us the best chance at a successful result. Whether we’re talking about cooling, drying, or cleaning, the longer that the material is in contact with the laminar airflow the better the results will be.
In this photo, the Super Air Knife is positioned upside down at an angle above a conveyor belt, against the direction of travel. We recommend installing the Super Air Knife in this orientation as it allows the airflow to get closest to the material being blown off. They’ve used their own brackets to allow the knife to be adjusted when blowing residual dust off of a conveyor for a mining application. The dust on the belt would build up over time and was difficult to remove. By installing a Super Air Knife, they’re able to continuously remove the dust from the conveyor belt before it becomes a problem.
If you have an application that would be better served with one of EXAIR’s Super Air Knives, give us a call. An Application Engineer is ready to assist you in selecting the proper material, length, and mounting method.