Care and Feeding Of Your Reversible Drum Vac

Published on by Russ Bowman

EXAIR’s Reversible Drum Vac couldn’t be easier to operate. Thread it in to the 3/4 NPT vent connection on your drum lid, install the Standpipe & Hose on the 2 NPT bung, hook up a compressed air line to it, and you’re in business. As long as your compressed air is clean & moisture free, your Reversible Drum Vac will run like new for a long, long time.

Should you start to see a decrease in performance, though, the first thing you’ll want to do is verify the compressed air supply, especially if something’s changed:

  • Did you get a new hose? The Reversible Drum Vac uses 19 SCFM @80psig for rated performance. That’ll require a 3/8″ ID hose, assuming a length of no more than about 20ft.
  • Are there any restrictions in the line? The usual suspects are clogged filters, partially closed valves, or push-to-connect quick-connect fittings.
  • Are there any vacuum leaks in the hose, its cuffs, the drum, or either threaded connection? If the lid’s removable, is that gasket intact?
Pro tip: a pressure gauge, right at the inlet, will give you instant indication of an air supply issue with your RDV (or any compressed air-operated product.)

If you’ve eliminated all of those potential problems, it’s time to take a look at the Reversible Drum Vac itself. The Reversible Drum Vac has tight internal passages that contamination from even the cleanest compressed air systems can build up in, over time. Good news is, we made it super easy to disassemble & clean, and better news: this almost always restores it to as-new performance. We even have a video that walks you through it:

You may be surprised not at how much, but how little contamination you find inside the Reversible Drum Vac. We offer factory refurbishment service for them as well…the procedure in the video is step-by-step what that service consists of, except we also replace the Shim, O-Rings, & Float, and when we reassemble it, we verify performance on the same fixture that every single new Reversible Drum Vac that we build gets tested on. Recently, a customer sent a Reversible Drum Vac in for refurbishment services after we’d spent some time talking on the phone, exchanging emails, and even a brief Engineering Consultation web meeting, troubleshooting their loss of vacuum. I was particularly curious about this one, so when it came in, I tested it (on our calibrated test fixture) for performance, and found it was only generating about 22% of rated vacuum, and only 17% of rated flow. I figured it was clogged (with a capital CLOGGED) so I match marked the body & plug (just like we show in the video) and took it apart:

I was frankly surprised at how little contamination (which appeared to be rust from the customer’s compressed air piping system) caused such a dramatic loss of vacuum.

We then completed the Refurbishment Service and tested it again. Performance was verified to be within specification for a new High Lift Reversible Drum Vac.

I offer to share the Cleaning & Refurbishing video with just about anyone who calls to discuss performance (or lack thereof) of their Reversible Drum Vac. Some still want to send theirs in for Refurbishment Service, and that’s fine. If you have a Reversible Drum Vac that’s not working properly, I’m here to help you get the most out of our products — any of them — give me a call.

Russ Bowman, CCASS

Application Engineer
Visit us on the Web
Follow me on Twitter
Like us on Facebook

Leave a Reply