When we talk with customers about their EXAIR Products, we also discuss the quality of their compressed air. Many of our products have no moving parts and are considered maintenance-free when supplied with clean, moisture free compressed air. One of the most critical aspects of a compressed air distribution system is the dryer.
No matter where you are in the world, the atmospheric air will contain water vapor. Even in the driest place in the world, McMurdo Dry Valley in Antarctica, there is some moisture in the air. As this air cools to the saturation point, also known as dew point, the vapor will condense into liquid water. The amount of this moisture will vary depending on both the ambient temperature and the relative humidity. According to the Compressed Air Challenge, a general rule of thumb is that the amount of moisture air can hold at a saturated condition will double for every increase of 20°F. In regions or periods of warmer temperatures, this poses an even greater problem. Some problems that can be associated with moisture-laden compressed air include:
- Increased wear of moving parts due to removal of lubrication
- Formation of rust in piping and equipment
- Can affect the color, adherence, and finish of paint that is applied using compressed air
- Jeopardizes processes that are dependent upon pneumatic controls. A malfunction due to rust, scale, or clogged orifices can damage product or cause costly shutdowns
- In colder temperatures, the moisture can freeze in the control lines
In order to remove moisture from the air after compression, a dryer must be installed at the outlet of the compressor. It is recommended to dry the compressed air to a dew point at least 18°F below the lowest ambient temperature to which the distribution system or end use is exposed. A dew point of 35-38°F is often sufficient and can be achieved by a refrigerated dryer (Best Practices for Compressed Air Systems). This makes the refrigerant dryer the most commonly used type in the industry.
A refrigerant dryer works by cooling the warm air that comes out of the compressor to 35-40°F. As the temperature decreases, moisture condenses and is removed from the compressed air supply. It’s then reheated to around ambient air temperatures (this helps to prevent condensation on the outside of distribution piping) and sent out to the distribution system.
With your air clean and dry at the point of use, you’re making sure you get the most out of EXAIR’s Intelligent Compressed Air Products without adhering to pesky maintenance procedures.