Medically speaking, our skin is an organ…and an amazing one at that. It protects our internals from an incredibly harsh environment as we’re bombarded by radiation (sunlight), subjected to summer’s heat & the cold of winter, attacked by fierce invaders (from viruses & bacteria to insects & spiders), all while we carry on at the bottom of a 60 mile-deep ocean (of air!)
Our skin requires some protection too: Sunscreen mitigates some of the harmful effects of solar radiation, shoes protect our feet from the ground, gloves & coats prevent frostbite, and compliance with OSHA Standard 1910.242(b) protects operators who use compressed air devices for cleaning purposes from air embolisms. That’s when air, under pressure, has enough energy to break the skin (tough as it is) and reach the tissue underneath. It’s painful, and serious enough that the victim should absolutely seek emergency medical treatment. If the air breaks a blood vessel and enters the pulmonary system, it can be deadly, in a hurry.
In 1971, the U.S. Occupational Health and Safety Administration (OSHA) determined that air under pressure higher than 30 pounds per square inch is capable of causing such injuries, if the pressurized source is dead-ended into the skin. Based on this determination, they included the following verbiage in Standard 1910.242, regulating the safe operation of hand and portable powered tools & equipment:
1910.242(b) Compressed air used for cleaning. Compressed air shall not be used for cleaning purposes except where reduced to less than 30 p.s.i. and then only with effective chip guarding and personal protective equipment.
In February 1972, OSHA issued Instruction STD 01-13-001 to clarify the meaning of 1910.242(b), with two illustrations of acceptable methods to meet compliance. The first is the use of a pressure reducer (or regulator):
The other method illustrated in the Instruction’s enclosures involves the nozzles themselves:
One design that complies with OSHA 1910.242(b) using this method is the cross drilled nozzle:
If you’re not concerned about high operating cost or deafening noise, you can stop reading now; these are all you need for OSHA compliance with Standard 1910.242(b). If you DO care about spending less money on compressed air or complying with OSHA Standard 1910.95(a) (which you read all about here), let’s spend a minute on engineered compressed air nozzles:
In addition to making them cost less to operate (since most of the total developed air flow is entrained), they’re also VERY quiet (since the entrained air forms a boundary layer on the outside of the air stream), AND they can’t be dead ended:
All EXAIR Intelligent Compressed Air Products, in fact, incorporate a form of built-in “relief device”:
If you’d like to discuss safe use of compressed air, it’s one of our primary goals here at EXAIR – give me a call.
Russ Bowman, CCASS
Visit us on the Web
Follow me on Twitter
Like us on Facebook