Consider these Variables When Choosing Compressed Air Pipe Size

Here on the EXAIR blog we discuss pressure drops, correct plumbing, pipe sizing, and friction losses within your piping system from time to time.   We will generally even give recommendations on what size piping to use.  These are the variables that you will want to consider when selecting a piping size that will suit your need and give the ability to expand if needed.

The variables to know for a new piping run are as follows.

  • Flow Rate (SCFM) of demand side (products needing the supplied compressed air)
  • System Pressure (psig) – Safe operating pressure that will account for pressure drops.
  • Minimum Operating Pressure Allowed (psig) – Lowest pressure permitted by any demand side point of use product.
  • Total Length of Piping System (feet)
  • Piping Cost ($)
  • Installation Cost ($)
  • Operational Hours ( hr.)
  • Electical Costs ($/kwh)
  • Project Life (years) – Is there a planned expansion?

An equation can be used to calculate the diameter of pipe required for a known flow rate and allowable pressure drop.   The equation is shown below.

A = (144 x Q x Pa) / (V x 60 x (Pd + Pa)
Where:
A = Cross-Sectional are of the pipe bore. (sq. in.).
Q = Flow rate (cubic ft. / min of free air)
Pa = Prevailing atmospheric absolute pressure (psia)
Pd  = Compressor discharge gauge pressure (psig)
V = Design pipe velocity ( ft/sec)

If all of these variables are not known, there are also reference charts which will eliminate the variables needed to total flow rate required for the system, as well as the total length of the piping. The chart shown below was taken from EXAIR’s Knowledge Base.

Piping

Airflow Through 1/4″ Shed. 40 Pipe

Once the piping size is selected to meet the needs of the system the future potential of expansion should be taken into account and anticipated for.   If no expansion is planned, simply take your length of pipe and start looking at your cost per foot and installation costs.    If expansions are planned and known, consider supplying the equipment now and accounting for it if the additional capital expenditure is acceptable at this point.

The benefits to having properly sized compressed air lines for the entire facility and for the long term expansion goals makes life easier.   When production is increased, or when new machinery is added there is not a need to re-engineer the entire system in order to get enough capacity to that last machine.   If the main compressed air system is undersized then optimal performance for the facility will never be achieved.   By not taking the above variables into consideration or just using what is cheapest is simply setting the system up for failure and inefficiencies.   All of these considerations lead to an optimized compressed air system which leads to a sustainable utility.

Brian Farno
Application Engineer Manager
BrianFarno@EXAIR.com
@EXAIR_BF

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: