Improving Auger Cleaning Process Using 2″ Flat Super Air Nozzles And Swivels

I recently worked with a customer who was looking to improve the cleaning process on the  inside of one of their screw augers. They were currently using a couple of 1/4″ pipes as air wands to clean the left over powder on the auger blades and direct it toward a chute at the bottom which fed into another auger used for recovery. While the setup worked somewhat, they were concerned with the amount of air they were using as well as the OSHA safety concerns associated to using open ended pipes and excessive noise levels.

The customer was able to send a sketch of their current setup and after some further conversations, I recommended our Model # 1122 2″ Flat Super Air Nozzle and our Model # 9053 1/4″ NPT Swivel Fitting. The 2″ Flat Super Air Nozzle produces a 2″ wide, high velocity laminar airflow and uses only 21.8 SCFM (80 PSIG) while maintaining a low sound level of only 77 dBA. The Swivel Fitting allows for 50 degrees of movement, so they can achieve the best angle to direct the air to the critical areas.

2″ Flat Super Air Nozzle
Swivel Fittings available from M4 up to 1″ NPT

All of our Air Nozzles are engineered to meet or exceed OSHA Standard 1910.24(b) for 30 PSIG dead end pressure, they cannot be dead-ended, there is always a path for the air to safely exit so the outlet pressure will never reach 30 PSIG. In addition, our products are going to meet the OSHA Standard CFR 29 – 1910.95(a) for allowable noise exposure levels as well.

If you are looking to reduce air consumption and noise while improving operator safety, give us a call at 800-903-9247 for assistance.

Justin Nicholl
Application Engineer

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s