Last week, I received an email from a satisfied customer, after he had already purchased our product. Come to find out this customer had not spoken to an application engineer during the planning stage to make their purchase. With our excellent resources listed at EXAIR.com, the customer was able to fulfill his application without even speaking to us. After his initial email of thanks, he also shared with me some details of his application that I want to share with you today.
The customer works as a machinist at a large aircraft part manufacturer. The parts require a very tight tolerance. A sample of each part needed to be gauged and measured in an automatic thread gauging machine or a coordinate-measuring machine (CMM). Their machining process required a water based flood coolant, so each part would be coated in water based coolant and chips, which needed to be remove before gauging. Before visiting EXAIR’s site, the company used a variety of homemade and commercial blow offs, as safety air gun tips. Here is a photo of (20) of the (25) nozzles the customer was using.
As you can see, the nozzles vary in design purpose, flow and safety. Most of the nozzles feature a cross drilled hole or a secondary escape path, but not all of the nozzles do. Any nozzle without a secondary relief port violates OSHA standard CFR 1910.242(b), so replacing some of the nozzles increased the safety in the plant. Secondly, these nozzles are wasteful in their use of compressed air because some were designed as liquid nozzles and have large exit holes. A hole that is 1/8″ in diameter at the nozzle outlet can consume up to 21.4 SCFM of compressed air at 80 PSIG. For comparison, the model 1103 Mini Super Air Nozzle with a 1/8″ NPT inlet will flow 10 SCFM at 80 PSIG, which would be a 53% compressed air savings. In 24 running hours, the 1103 nozzle will save 16,416 Standard Cubic Feet, which the plant spent $4.10 for a standard industrial compressor to produce (The standard for compressed air cost is $0.25 per 1,000 SCF). Replacing just one 1/8″ drilled hole with 1103 Mini Super Air Nozzle saves the aircraft company $1,026 over 250 working days running 24 hours a day.
Neither of these were the real reason that the customer emailed to thank us though. He was actually an office employee just entering the work force. Starting in June until after the company finally acquiesced to his request to buy a better, quieter nozzle near the end of July, he had left work needing an aspirin to relieve the headache he acquired due to the noise from these other nozzles. The nozzles the machining center had been using would create noise levels between 88-100 dBA at 80 PSIG of inlet pressure. For reference OSHA mandates that employees are required to wear hearing protection, if they are exposed to noise levels over 90 dBA over an 8 hour work day. The employees doing the machining wear hearing protection, but the employees in the office were still exposed and affected by the noise level. This is just one anecdotal example, but everyday more and more research shows that noise exposure has a negative effect on our health and productivity in the workplace. If you are interested in more information here are some links to a number of studies/research – please read this, here or this.
Anyway, that’s enough of my soapbox. The company purchased 25 of EXAIR’s 1103 Mini Super Air Nozzles and utilizing the same guns they were currently using saw between a 10-15 dBA decrease in noise levels near the work stations. Here is a photo of one of their setups with the model 1103 installed on one of their current air guns.
We know that every time they squeeze that air gun trigger they will be using less compressed air than before, and we know they are now in compliance with OSHA. But the best benefit for EXAIR is we know that the engineer took the time to email us to thank us for taking away his headache everyday. That’s enough for me.