A few weeks ago I received an inquiry from a customer who was looking to blow water off the inside of a closed cylinder after a zinc bonding process. There are 8 parts that are placed on a manifold which is then inverted and sent into their current blow off setup that includes small open tubes that get inserted into each cylinder to try and blow out the water. This setup worked a little but the issue they were experiencing was the airflow coming out of the tubes was blowing the water up, which caused it to collect in the “bowl” of the cylinder and as the blow off tubes were removed, the water would start to leak back out and down the inside walls again. After the current blow off, the parts are manually removed and inspected for moisture content. If the parts are found to be outside of their tolerances, an operator uses a modified blow gun fitted with a small tube to manually complete the process.
After discussing the particulars with the customer, their needs were two-fold – first they needed a nozzle that wouldn’t push the air toward the end of the tube but something that would direct the air “backwards” so as they placed the nozzle inside, they could hopefully “pull” the liquid out as the nozzle is removed. The second concern was the cylinder had a small 0.390″ diameter opening so the nozzle would need to be small and powerful enough to be able to fit inside the part, while still providing effective blowoff.
Once again, EXAIR offered the perfect solution, our Model # 1004SS M4 Back Blow Nozzle. The Back Blow Air Nozzle produces an even, 360° airflow that is directed away from the end of the nozzle. At only 0.20″ in diameter, The Model # 1004SS is the ideal choice for treating the inside diameter of small hose, pipe, bores (up to 1″) or in this case, small enough to fit inside the opening of the cylinder. With this design blowing the air back away from the end, the water wouldn’t get trapped in the bowl but rather would allow the inside walls of the cylinder to be wiped clean while directing the liquid toward the opening so the water can be removed.
In addition to the Model # 1004SS M4, we also offer our Model # 1006SS 1/4″ NPT Back Blow Nozzle for use with 7/8″ to 4″ ID’s, as well as our Model # 1008SS 1″ NPT unit for treating large ID”s up to 16″, for larger scale applications