Proper Compressed Air Supply Plumbing Equals Success

EXAIR manufactures and stocks Super Air Knives in lengths ranging from 3”-108”. They’re designed to dramatically reduce compressed air usage when compared to similar blowoffs while still maximizing both force and flow. With an air entrainment ratio of 40:1, it’s the ideal solution for a variety of applications that necessitate a wide, laminar sheet of high velocity airflow.

I recently worked with a customer who makes wooden pallets. They were using a Model 110048 48” Super Air Knife to remove sawdust from the pallets prior to stacking them. When the grooves are cut into the pallet to accommodate the forks from a forklift or pallet-jack, there’s a good amount of sawdust that remains on the pallet. They would prefer to not have sawdust all over the finished pallets that they send to customers, so they looked towards a Super Air Knife to provide a curtain of air capable of removing that sawdust just prior to stacking them.

They purchased the Model 110048, but after installing it they didn’t get the level of force they had been hoping for. After some initial discussions, we identified that the issue lied with the plumbing of the air supplied to the knife. A 48” Super Air Knife will need to be fed with compressed air to (3) of the ¼ NPT air inlets. This ensures that an adequate volume of air is fed to the full length of the knife, keeping a consistent airflow.

Not only had they been plumbing compressed air to just (1) air inlet, but they were also using a restrictive quick-disconnect fitting. The I.D. of a quick connect fitting restricts the overall volume of air that can be passed through it. Length of the pipe or hose is also critical as the diameter of the pipe will need to be larger for longer runs or greater volumes. Accompanying any Super Air Knife is our Installation & Maintenance Guide which outlines the necessary requirements for each available length that we have available as well as how many air inlets need to be supplied with compressed air.

SAK pipe sizing

To confirm that air supply was the issue, they installed a pressure gauge directly at the air inlet to the knife. Line pressure was around 90 PSIG, but when they opened the valve and supplied air to the knife the pressure gauge dropped all the way to 35 PSIG. We’ve talked about pressure drop before here on the EXAIR Blog, the only way to confirm this is to take a pressure reading directly at the air inlet.

They removed the quick disconnect fitting, increased to a 1/2″ supply hose in place of 1/4″, and plumbed compressed air to each end and the center air inlet. On all Super Air Knives, compressed air inlets are available on either end as well as on the bottom. After fixing their plumbing, they noticed a dramatic increase in both force and flow and the pressure directly at the air inlet increased to 85 PSIG. The sawdust was easily blown off of the pallets and the customer was pleased that their pallets were free of sawdust.

sak pallet

At EXAIR, we stand by our products with the Unconditional 30 Day Guarantee. If you’ve just purchased a new product and aren’t seeing the results that you were hoping for give us a call. Our highly-trained team of Application Engineers is ready and standing by to investigate the application and provide support to help make sure you’re getting the most out of our products. Most of the times the solution is simple, but we won’t be satisfied until we find a resolution!

Tyler Daniel
Application Engineer
E-mail: TylerDaniel@EXAIR.com
Twitter: @EXAIR_TD