Okay, in case you haven’t been around the past year or two, and you have no clue where that simple word/statement comes from, then let me be the first to tell you that Ted Lasso is a great show, and you should check it out. So what does that have to do with EXAIR? Well, I like to think that sometimes the Application Engineers here are a lot like the coaching staff on the show. Sometimes we are strategic, we want to assert our experience and knowledge, and others, we are like Ted where we just ensure the thoughts and ideas you have already had.

That’s the fun part of being an Application Engineer here at EXAIR. I get to speak, chat, or email with both existing customers and potential new customers, resellers, and even catalog houses who all are trying to do one thing, improve a process or help someone out. Recently I was working with a manufacturing company trying to determine how fast they can cool a slab of steel with a Super Air Knife. Now, I by no means have a background in thermo like Russ Bowman, but he was busy preparing for our Spring Webinar to share some knowledge on Compressed Air System Storage. (If you haven’t checked a webinar out, most are available on our website in our knowledge base. ) So, I took the time to try and remember some of the tools I learned while at the University of Cincinnati. Thermodynamics was by far one of the hardest classes for me, The Algebra was always easy, I just always looked at the problems sideways I guess, and worried about too many variables. The truth of it is, if you keep it simple you can generally get somewhere close. so I took that approach. First I looked at what heat load would be generated by the steel slab.

\K.I.S.S. – Keep It Simple Stupid – Not always my forte!

I looked at the basic Heat Transfer equation – Q=c x m x ΔT where:

Q = Heat
c = specific heat capacity
m = mass
ΔT = Change in temperature

I was able to locate the mass of the carbon steel plate with 1/2″ thickness. So I calculated the mass of the sheet. Then looked up the specific heat of the same plate, and took the change in temperature from what the customer stated the plate started at and finished at.

This resulted in a heat load. Then to calculate how much cooling a Super Air Knife could provide I utilized another calculation that gives the BTU constant of a cubic foot of air moving and I did decrease the efficiency of the knife due to some assumptions on space and temperature constraints. The resulting factor was the customer would need 6 Super Air Knives to blow the sheet down as it travels 5 feet per minute on a 60′ long conveyor.

This again had several assumptions and I made that very clear to the customer. To convert the amount of air a Super Air Knife puts out and how much cooling it can use, I did make some clear assumptions on the temperature of their atmosphere and the amount of entrainment then I used a calculation that we adapt for Vortex Tubes and Cabinet coolers to determine what cooling load will be achieved if the air pressure or temperature is less than optimal on one of those products.

In the end, the customer received an educated estimation or calculated answer with listed assumptions, to solve their issue with cooling a steel slab before it is stacked together. I really only used two calculations and manipulated some variables to try and make sense of what I knew and what the customer needed. The best part is, this whole process is backed by our 30-day guarantee on stock products which our 48″ Super Air Knife is. So this customer can take my basic math, use my suggestions, place an order, and test it out in their facility for a factual performance test to then proceed with a permanent solution.

If you would like to discuss any point of use or potential application for compressed air in your facility, please contact an Application Engineer today!

Brian Farno
Application Engineer

Leave a Reply