I had the pleasure of discussing a spot cooling application with a customer this morning. He wanted to get more flow from his Adjustable Spot Cooler, but still keep the temperature very low. He machines small plastic parts, and he’s got enough cold flow to properly cool the tooling (preventing melting of the plastic & shape deformation) but he wasn’t getting every last little chip or piece of debris off the part or the tool.
After determining that he had sufficient compressed air capacity, we found that he was using the 15 SCFM Generator. The Adjustable Spot Cooler comes with three Generators…any of the three will produce cold air at a specific temperature drop; this is determined only by the supply pressure (the higher your pressure, the colder your air) and the Cold Fraction (the percentage of the air supply that’s directed to the cold end…the lower the Cold Fraction, the colder the air.)
Anyway, the 15 SCFM Generator is the lowest capacity of the three, producing 1,000 Btu/hr of cooling. The other two are rated for 25 and 30 SCFM (1,700 and 2,000 Btu/hr, respectively.)
He decided to try and replace the 15 SCFM Generator with the 30 SCFM one…his thought was “go big or go home” – and found that he could get twice the flow, with the same temperature drop, as long as he maintained 100psig compressed air pressure at the inlet port. This was more than enough to blow the part & tool clean, while keeping the cutting tool cool, and preventing the plastic part from melting.
If you’d like to find out how to get the most from a Vortex Tube Spot Cooling Product, give me a call.