Simplifying Plastics Machining Using The Cold Gun And Chip Vac

I was recently contacted by a plastics manufacturer who was needing some solutions for problem areas in their production processes. The company imports their machines from overseas and they are outfitted with a coolant based, quench system for the tooling. They were wanting to get away from using coolant as the parts were absorbing liquid, causing them to swell, not to mention the mess they were creating, requiring more time and labor to dry and clean the parts manually.

For the first application, replacing the messy misting system, I recommended the customer use our Cold Gun System, Model # 5215. The Cold Gun uses Vortex Tube technology to produce a cold air stream 50°F lower than the incoming compressed air supply temperature. For example, if your supply air was ambient 70°F, you would effectively see 20°F air at the exhaust. This clean, cold air stream can be easily directed to the needed area to prevent any warping or other damage related to heat, while also blowing away the machined fines.

Model # 5215 – includes the Cold Gun, Single Point Hose Kit, 3/8″ Cone Nozzle, 1-1/4″ Fan Nozzle and Filter Separator

The second part of the process involved the recovery of the plastic scrap and chips created during the machining process. Once again, EXAIR has the ideal solution with our Chip Vac, Industrial Vacuum. The Chip Vac creates a powerful vacuum, with no moving parts or motors to wear out, making them virtually maintenance free. The Chip Vac is designed to vacuum dry or wet chips and collect them in a standard, open-top steel drum. Systems are available in 5, 30, 55 or 110 gallon capacities.

From small area clean up to larger scale processes, the Chip Vac has you covered

To discuss how EXAIR products might help improve your machining process, give us a call at 800-903-9247.

Justin Nicholl
Application Engineer
justinnicholl@exair.com
@EXAIR_JN

Adjustable Spot Cooler: How Cold Can You Go?

I had the pleasure of discussing a spot cooling application with a customer this morning. He wanted to get more flow from his Adjustable Spot Cooler, but still keep the temperature very low.  He machines small plastic parts, and he’s got enough cold flow to properly cool the tooling (preventing melting of the plastic & shape deformation) but he wasn’t getting every last little chip or piece of debris off the part or the tool.

After determining that he had sufficient compressed air capacity, we found that he was using the 15 SCFM Generator. The Adjustable Spot Cooler comes with three Generators…any of the three will produce cold air at a specific temperature drop; this is determined only by the supply pressure (the higher your pressure, the colder your air) and the Cold Fraction (the percentage of the air supply that’s directed to the cold end…the lower the Cold Fraction, the colder the air.)

Anyway, the 15 SCFM Generator is the lowest capacity of the three, producing 1,000 Btu/hr of cooling. The other two are rated for 25 and 30 SCFM (1,700 and 2,000 Btu/hr, respectively.)

He decided to try and replace the 15 SCFM Generator with the 30 SCFM one…his thought was “go big or go home” – and found that he could get twice the flow, with the same temperature drop, as long as he maintained 100psig compressed air pressure at the inlet port.  This was more than enough to blow the part & tool clean, while keeping the cutting tool cool, and preventing the plastic part from melting.

Model 3925 Adjustable Spot Cooler System comes with a Dual Outlet Hose Kit, and three Generators for a wide range of cooling performance.

If you’d like to find out how to get the most from a Vortex Tube Spot Cooling Product, give me a call.

Russ Bowman
Application Engineer
Find us on the Web
Follow me on Twitter
Like us on Facebook