This blog may get a little uncomfortable for some of us. It revolves around a subject that can strike fear into the hearts of many and just the thought of it can make sounds or smells come back from memory. For me, the sound of the high-pitched drill is precisely what comes to mind when I think of the Dentist….
That’s right, today we are talking about the Dentist. Well, more so a vendor for dentists that still deals with teeth. This manufacturer came to me looking for a way to improve their compressed air consumption on a tooling blowoff for the machining of dental crowns. They used custom-made blowoffs to try and remove the residual material on their cutting tools before contacting a new part and during the machining of a crown. The customer didn’t have a ton of room, and they did not want to redesign the entire blowoff. The blowoff was essentially an open pipe that had a .085″ diameter. Each machine station had three blowoffs, there are 20 machining stations per production line, with five total production lines. So any savings will add up quickly over 300 blowoff points.
They were able to cut back and thread the end of the open blowoff for one of our 1108SS Atto Super Air Nozzles. The open blowoff was consuming 6 SCFM when operating at 80 psig inlet pressure for each blowoff point. For a single machining center that equates to 18 SCFM per center. 18 SCFM times 20 machining centers equals 360 SCFM of consumption per production line. Implementing the 1108SS reduced the consumption to 2.5 SCFM @ 80 psig per nozzle and gave a more defined blowoff pattern. 2.5 SCFM times 3 nozzles per center equates to 7.5 SCFM. 7.5 SCFM times 20 machining centers per production line totals 165 SCFM per production line. 360 SCFM minus 165 SCFM equates to 195 SCFM of compressed air savings by installing the further engineered solution.
Per nozzle, they can save up 72 cents per twelve-hour shift. While this does not seem like much, multiply that across 300 nozzles installed. You end up with $216.00 saved per twelve-hour shift. Some other breakdowns are shown below.
If you would like to discuss just how much a “little” open pipe blowoff is costing you, contact an Application Engineer today!
Brian Farno
Application Engineer
BrianFarno@EXAIR.com
@EXAIR_BF