I recently had the pleasure of helping a long-time user of our Super Air Knives with a challenging application. They already use quite a few of our Model 110012SS 12″ Stainless Steel Super Air Knivesto clean & dry their nonwoven material as it’s being rolled for packaging. They like them because they’re quiet and efficient, but also because they’re durable…this particular product off-gasses a mildly corrosive vapor, which used to corrode other equipment in the area. Not only does the Stainless Steel Super Air Knife resist corrosion itself, the air flow keeps these vapors contained. Two birds, one stone.
They have a new product…same kind of material, but much wider…that needed to be blown off, and the identified the Model 110060SS 60″ Stainless Steel Super Air Knife as a “no-brainer” solution. Thing is, it had to be a pretty even air flow across the length, and a 60″ Super Air Knife has to get air to four ports across its length for optimal performance. And, they wanted to install it at a point where it would serve not only as a blow off, but as a vapor barrier, just like the 12″ Super Air Knives they’re already so fond of. The space was a little limited, though, so they opted for the Model 110060SSPKI 60″ Stainless Steel Super Air Knife with Plumbing Kit Installed, which allowed them to simply run an air supply line to both ends.
If you want to find out more about an engineered solution for your compressed air application – cleaning, drying, vapor barrier, or all of the above – give me a call.
Incorrect plumbing is an all too common problem we deal with on a regular basis here at EXAIR. Many times we receive calls from a customer saying that their Air Knife isn’t producing a high velocity or they are seeing an uneven airflow. In fact we have written many blogs touching on this subject, such as the one I posted a few weeks ago titled, Proper Air Supply & Installation Provides Best Performance or the one titled Typical Compressed Air Plumbing Mistakes by our International Application Engineer John Ball.
Using undersized supply lines can cause excessive pressure drops because they aren’t able to carry the volume of air necessary to properly supply the compressed air device. We commonly reference trying to supply water to a fire hose with a garden hose, it is the same principle. Using restrictive fittings, like quick disconnects, will also contribute to this effect as the ID of the fitting is much smaller than the NPT connection size. Example: Say you are seeing 80-100 PSIG upstream of an air knife at the pressure gauge, by the time the air passes through a quick disconnect or small ID line and fitting, the actual pressure being delivered to the unit will be much less, possibly as low as 20-30 PSIG depending on the installation. One way to measure the actual pressure being delivered to the air knife would be to install a pipe tee with a pressure gauge right at the inlet of the air knife.
All of our products are shipped with an installation guide referencing the proper recommended pipe sizes for various lengths of supply pipe. When dealing with our Air Knives, since we offer lengths up to 108″, you need to plumb air to multiple inlets for knives that are 24″ and larger. To simplify the installation process, we offer our Air Knife Plumbing Kits. The Plumbing Kits include properly sized nitrile/PVC compressed air hose and brass fittings for our aluminum units. In addition, we now offer 316ss pipe and fittings for our stainless steel and PVDF Super Air Knives for applications requiring superior corrosion resistance. Using the plumbing kits eliminates pressure loss and the need for searching for the proper fittings or possibly using incorrect pipe size.
If you think you are experiencing less than expected performance from one of our products, please give us a call so we can help.