There Must Be A Better Way To Save…

 

I’m writing this blog at almost the top-dead-center midpoint of Spring Break week. My teenage sons have been “enjoying” their time off thus far with the housekeeping duties their mother has been assigning them, and the labor they’ve been providing their uncle, as he installs a new garage door for us…the one my mother-in-law paid for. I definitely married out of my league.

The last half of Spring Break, though, we’re taking a little vacation. We looked at the activities and attractions at our destination, came up with a plan on what to do and when (including an analysis of the 10 day weather forecast…which prompted me to find our rain ponchos) and have even purchased some tickets in advance, because advertising “5% SAVINGS!” on stuff really works on me, even when it’s on a $20 ticket. Before you grab your calculator, yeah…that’s a dollar. But since there are four of us, I’ve multiplied our savings by 400%! Yes; I know…four bucks.  Still, I’ll take it.

We talk to folks almost every day who want, like I do, to save money on goods and services they’re going to purchase anyway. Some have performed comprehensive energy audits, and identified opportunities to lower their compressed air generation and/or consumption rates. Others have just been looking at the bent copper tubes that are blowing off their parts and thinking there has to be a better way.

(Full disclosure: I’ve had these two exact conversations so far this week.)

Today, I want to tell you about the latter: It’s an aluminum casting plant with about a dozen lines where a robot grabs a fresh casting from the machine, dips it in a quench tank, and holds it in front of an array of copper tube blow offs for a few seconds before placing it in a bin, bound for the machine shop. Not only were they blowing at it from both sides with the copper tubes, but they were also blowing continuously…including the majority of the cycle time that did NOT include holding the part in the air flow.  Dear reader, if you’re familiar AT ALL with the EXAIR blog, you’ll know that we simply cannot abide that. Continuous flow when flow is only needed a fraction of the time is wasteful and expensive. Not to mention blowing air out of open tubes is dangerous, loud and requires and unneccessary volume of compressed air.

It's like they WANT to upset us.  What's up with that?

It’s like they WANT to upset us. What’s up with that?

They installed (2) Model 110018 18” Aluminum Super Air Knives, in place of the copper tubing, which cut down on their air consumption…and noise levels…considerably. I gave them some further recommendations on reprogramming the robot to turn the part in front of one Air Knife, and using an EFC Electronic Flow Control to turn the air off when a part was not present.

EXAIR's EFC automatically turns the air off when a part is not present.

EXAIR’s EFC automatically turns the air off when a part is not present.

Is there a better way to use the compressed air in your facility? Whether you’ve got comprehensive data from a detailed audit, or if that open pipe is just too darn loud, all the time – give me a call…we’ll find out.

Russ Bowman
Application Engineer
Find us on the Web
Follow me on Twitter
Like us on Facebook

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: